Gravel and Stone Calculator
Estimate gravel, stone, sand, or soil volume for a rectangular area. Use your material density and price to calculate weight and cost.
Interactive workspace
The workspace uses JavaScript. Read the instructions, method, and worked results while it becomes available.
Read the worked examplesHow to use Gravel and Stone Calculator
- Enter the area's length, width, and fill depth in metric or imperial units.
- Optionally enter a waste allowance, supplier density, and unit price.
- Calculate volume and any supported weight or cost estimates.
What is Gravel and Stone Calculator?
The same volume can have different weights depending on material type, grading, compaction, and moisture. This calculator separates geometry from density: dimensions determine volume, while your supplied density determines mass. Metric tonnes and US short tons are labeled separately to prevent ordering mistakes.
- Volume in cubic meters, feet, and yards
- Supplier-specified density instead of hidden material assumptions
- Kilograms, pounds, metric tonnes, and US short tons
- Optional waste allowance and unit-price estimate
Check the supplier’s bulk and billing units
Bulk density depends on the material and measurement basis. Ask whether the supplied figure refers to loose or compacted material and how moisture is treated. With density blank, ADEMN reports volume without inventing a weight.
A US short ton is 2,000 lb and a metric tonne is 1,000 kg. They cannot be substituted in a price without conversion. Load the imperial example to see the same layer expressed in both. Delivery, compaction work, minimum orders, and other charges remain outside the entered unit-price estimate.
NIST: conversion factors and derived unitsWorked examples you can try
Each example uses illustrative inputs. Load its named preset in the calculator above, then calculate to compare with the expected result.
A gravel layer, volume only
A volume does not imply a weight when bulk density is unknown.
5 m × 4 m × 5 cm Allowance: 0% · Density: blank
1 m³ Weight is not estimated.
Price an imperial layer by the short ton
Use the supplied bulk density and distinguish US short tons from metric tonnes.
10 ft × 10 ft × 1 ft Illustrative density: 100 lb/ft³ · USD 50 per US short ton
100 ft³ · 10,000 lb 5 US short tons · 4.535924 metric tonnes Estimated cost: USD 250.00
Learn a little more
From floor area to material volume and weightFrequently asked questions
Why must I supply a density to get weight?
A material name alone does not determine its bulk density. Ask your supplier for a value matching the delivered material and its condition.
Are all tons the same?
No. A metric tonne is 1,000 kilograms; a US short ton is 2,000 pounds. This calculator identifies each explicitly.
Does the estimate include compaction?
There is no automatic compaction factor. Use dimensions, density, and an allowance that match your supplier's measurement basis.